Connect · Section 6
Add the device to DozaLink
Link the device to your account by scanning its label or typing its serial number.
Linking adds the device to your organization so you can manage it from dozalink.com.
You need
- An active subscription. The account owner starts it on the Billing page.
- Owner, admin, or operator access to the site.
- The device label with its serial number and QR code.
- The device connected to Wi-Fi.
Link it
- Open Devices and click Link device.
- Tap Scan QR code and scan the label, or type the Serial number as printed.
- Click Check serial number and check that DozaLink found the right device.
- Enter a Device name people will recognize, such as "Bay 2 presoak", and choose its Location.
- Click Link this device and wait for it to show Online.
Set up dosing after linking
A newly linked device starts with all wash triggers off and its factory tubing and direction settings. Then work through tubing and direction, calibration, and wash triggers.
If linking fails
Read the message, fix the cause (usually billing or Wi-Fi), and try again with the same label. A device belongs to one organization at a time; if it was used elsewhere, that organization must unlink it.
Lock on-device settings
An admin can stop pump settings from being changed in setup mode: on the device’s page, under On-device settings, click Lock local controls. Wi-Fi setup stays available. Click Allow local controls to undo it.
Unlink a device
On the device’s page, click Unlink device and type UNLINK. Its history is kept. If it is linked again, set up dosing again.